Kingston HyperX CloudX Speaker Sponge Replacement

Written By: Kosie
  • Comments: 0
Kingston HyperX CloudX Speaker Sponge Replacement

Difficulty

Easy

Steps

5

Time Required

10 - 15 minutes

Introduction

Are the speaker sponge on your headset ripped or missing? If so, here is the guide to remove the sponge pad so that you will be able to attach new ones. All you need for this replacement is a 00 size cross screwdriver, a plastic and metal spudger, your new speaker sponge, super glue, and possibly some scissors. This replacement is easy to complete with no apparent hazards.

  1. pqvqkXqI6ALNunFW

    • Remove the ear cushion from the earphone.

  2. QHygNXDkZgCVsTAG
    QHygNXDkZgCVsTAG
    XtnYbD1NXE2jBOBd

    • Remove four 11.2 mm screws from the earpiece using a Phillips #00 screwdriver.

  3. omlKI3pwOBllwIBp
    omlKI3pwOBllwIBp
    KDMDakYBDnK3XBjs

    • Use a spudger to pry the top plate away from the motherboard.

    • There will be a groove in between the two plates to insert the spudger.

  4. RbSkdNUCTc5iJWXp

    • Use the metal spudger tool to scrape off the old foam pad and any remaining glue.

    • The plate does not have to be completely clean after removal, just clean enough to securely attach the new sponge.

  5. FoY5serWyn2EBi4J

    • Line the edge of the headphone plate where the original pad was with superglue.

    • Press the new sponge into the glue and allow it to dry fully.

    • The new sponge may need to be cut to size in order to fit on the headphone plate.

    • Make sure the glue is completely dry before reassembling your device. Failure to do this may result in damage of your device.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Kosie

Member since: 01/03/23

121 Reputation

0 comments