Karcher Carpet Cleaner 10066730 2014 Breaker Replacement

Written By: Carsten Frauenheim
  • Comments: 0
Karcher Carpet Cleaner 10066730 2014 Breaker Replacement

Difficulty

Moderate

Steps

6

Time Required

No estimate

Introduction

Use this guide to remove and replace one of the two breakers on the Karcher Carpet Cleaner 10066730.

Follow this same procedure to remove the opposite breaker.

Note: Before beginning repairs, disconnect the device from power, disconnect all hoses, drain and depressurize the system, and let the device cool if the heater was recently used.

  1. aSTWv2BpoJviivAT

    • Before beginning repairs, disconnect the device from power, disconnect all hoses, drain and depressurize the system, and let the device cool if the heater was recently used.

    • Use a Phillips screwdriver to remove the six screws securing the front panel.

  2. IGTAfVaBtJnYAPHl
    IGTAfVaBtJnYAPHl
    a6JQQ4U64WvHWPFO

    • Grip the front panel at the top and tilt down to reveal the switch electronics.

    • The front panel will stay attached to the device with the flexible tubing.

  3. IynISm2ncCgyMeHi

    • Use a 16 mm socket to loosen the nut on the breaker button cover.

  4. rrR1HUFVCJAe1tRK
    rrR1HUFVCJAe1tRK
    NEWdCYbyhO5ym3PZ

    • Remove the breaker button cover.

  5. YSxWBJSFFIwiZwJn
    YSxWBJSFFIwiZwJn
    dfgbMKXU1FEK1dTv

    • Separate the breaker from the front panel.

  6. XvLftGha2GUbM3SI
    XvLftGha2GUbM3SI
    L1trFZx2AVnJSOod
    iOfDTUN32wYFkv4t

    • Grip the black wire by its blue connector and pull directly away from the breaker to remove it.

    • Grip the dark blue wire by its blue connector and pull directly away from the breaker to remove it.

    • Make a note of which wire goes where to help during reassembly.

    • Only the breaker remains.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Carsten Frauenheim

Member since: 10/03/20

110978 Reputation

0 comments