Introduction
Tools
-
-
Firstly, take off lid by twisting anti-clockwise.
-
Remove the glass jar from the blender base by again twisting anti-clockwise.
-
-
-
The blender blade is attached to a base component at the bottom of the blender jar.
-
To remove the blade, simply twist the attachment according to the direction written, in this case, turning anti-clockwise.
-
The blade could be then easily taken out from the jar, if difficulties occur at this stage, simply adjust the blade's angle when removing so.
-
-
-
Remove four screws from the base of the blender
-
Take out the ventilation opening from the base. Keep screws aside.
-
-
-
The clutch is attached to the bottom of the blender. This can be twisted out directly with hand.
-
The disk attached inside the clutch can be pulled out after the clutch is removed from the blender bottom.
-
-
-
This little component is used to stabilise wires. It can be taken out after cutting the wires.
-
-
-
Lift out the major electronic part of the blender.
-
Cut off two pieces of wires, then take out the mini light bulb.
-
This is how the blender base should look like at the moment.
-
-
-
Unscrew the two screws from both sides of the clasp to detach all component, this includes the motor of the blender
-
-
-
To take out the back of the of blender speed dial, unscrew two screws that are located opposite each other.
-
-
-
After taking out the back of the speed dial, the dial will fall out itself.
-
There are three individual pieces that make up the speed dial: the ring, the metal and plastic casting.
-
To reassemble your device, follow these instructions in reverse order.