Introduction

This guide will aid the user in the installation of the capture button for this device. The capture button is the button that is pressed in order to take a picture. This device is to be used if for some reason the capture button breaks or is pushed into the device.

  1. KSYuoTOXyS3ObqZZ
    KSYuoTOXyS3ObqZZ
    Xf5XYFoqZ16MOd25
    • Flip the device so that the bottom is facing upwards. Using thumb, push the tab on the bottom in the direction indicated by the arrow and then lift the unhinged part of the tab.

  2. ue1o5OuiJWSTAdcI
    • Tilt device so that batteries slide out.

  3. NMQRrHQB1V1Ev3Kf
    NMQRrHQB1V1Ev3Kf
    IOAxBoWiqVuaKQbW
    j3EcbbZMGEgxLufJ
    • Carefully insert the flat end of the spudger into the seam on the top side of the device. Carefully twist the spudger to open the device. Repeat this step at incremental locations around the seam of the device until the two case halves separate.

    • Before completely separating the two halves, separate the case from the battery compartment cover, pulling the case apart. Take care not to break the plastic hinge as the battery compartment cover is removed.

  4. tXGTwUkR56P6xRZo
    tXGTwUkR56P6xRZo
    1BEpmdgNj6keMCCu
    IMJV55f4LKNymOue
    • There are two wires (one red and one black) that could get disconnected from the motherboard when prying the case apart.

    • Gently seperate the two halves of the device.

    • To remove the circuit board from the right section of the device, unscrew the two 5.6 mm Phillips #00 screws.

    • When the screws have been fully unscrewed, use the tweezers to remove them from the device.

  5. F6X4JcycyaWTRfTI
    • Carefully separate the grey side bar from the case and set it aside.

  6. aIteKlLkm6pvFCxP
    • Use the tweezers to grasp the bottom of the capture button. Pull the capture button away from the case and set it aside.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Katelyn Fry

Member since: 11/03/13

1 Reputation

0 comments