Insignia Ice Maker NS-IMP26SS7 Fan Replacement

Written By: Evan Taylor
  • Comments: 1
Insignia Ice Maker NS-IMP26SS7 Fan Replacement

Difficulty

Easy

Steps

5

Time Required

10 minutes

Introduction

This guide will show the steps required to disassemble an Insignia Ice Maker and replace the fan inside. It should take approximately 5-10 minutes.

  1. nmt16UKVWANT6nXI
    nmt16UKVWANT6nXI
    lh2xCIlYCkL6vYRB

    • Undo the 6 Screws found on the bottom edge holding the rear casing on.

    My Insignia ice maker doesn't work. Water gets cold but doesn't freeze. Thermostat issue?

    Burke Hansen -

  2. NDa51CbrNNSbgnrD

    • Pull the casing off.

  3. Gr1MQWDXM5ikr3qI
    Gr1MQWDXM5ikr3qI
    ZhYrl6NBTiN3tJFW

    • Locate the fan on the side of the Ice maker and undo the 4 screws holding it in place.

  4. xKbUrwuFx2qAeqHR
    xKbUrwuFx2qAeqHR
    hfhD6jjPa2qdQ2M4

    • Remove the cover from the circuit board by pressing against the lever to the side. A pry tool may be needed.

  5. fuJssTwAGJBvxFbA
    fuJssTwAGJBvxFbA
    lg4Kx2YWO3W2cxsK
    ZjCSeVBmNhTUuVDs

    • Follow the fan's power cable and unplug.

    • You may have to cut a zip tie holding the cable in place.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Evan Taylor

Member since: 18/01/18

616 Reputation

0 comments