Inse N500 Motor Replacement

Written By: Siaosi Kaufusi
  • Comments: 2
Inse N500 Motor Replacement

Difficulty

Moderate

Steps

8

Time Required

10 minutes

Introduction

If your Inse vacuum (model N500) is producing strange noises due to dust and debris in the motorhead, use this repair guide for the motor replacement.

  1. KLsHqkt2ytgfFNrP
    KLsHqkt2ytgfFNrP
    lLP6NkfiLIyVcdZp
    1rJEOJDKo4joYBs5

    • Unclip the plastic band from the vacuum head.

  2. FucFvBCJHA6BcghP
    FucFvBCJHA6BcghP
    LMOXwRZu5mTjsDeB

    • Remove six 6 mm screws using a Phillips #0 screwdriver.

  3. BNbPHZpgqkFOQwHh
    BNbPHZpgqkFOQwHh
    duOwIcUKXhe4jBiG

    • Remove the vacuum head guard.

  4. 63AHtWLMfOvgbqsX
    63AHtWLMfOvgbqsX
    rCMlhMc3KyMrcECm

    • Remove the ten 4 mm screws using a Phillips #0 screwdriver.

    • There are five screws on each side of the vacuum.

    Maybe add circle indicators, because in the photo there's 5 holes.

    Ryan Muscove -

  5. lAo4t1oYgSC2RIFh
    lAo4t1oYgSC2RIFh
    HG1APG5wLWrduqlW

    • Remove the single 4 mm screw from the circuit board using a Phillips #0 screwdriver.

  6. sd6nFvlVub5YcHt6
    sd6nFvlVub5YcHt6
    WAWDXnUTTu1eakEn

    • Unfasten the remaining clips.

  7. PSgUIpVMT5ORDxmQ
    PSgUIpVMT5ORDxmQ
    RaSHWQShmsQHVlkN
    GMVlJALFX25ZkM5c

    • Remove the dustbin.

  8. bAnil3FlYvCZSg3h
    bAnil3FlYvCZSg3h
    vyYNMaPwyyfPQ4ls

    • Unfasten the surrounding motor clips and remove the motor.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Siaosi Kaufusi

Member since: 12/09/23

661 Reputation

One comment

Please 🙏 the motor of roborock h7 please 🙏

Wayl -