Introduction

If your Inse vacuum (Model N500) dustbin is cracked, spilling out debris, or has distorted in a way that prevents closure, use this guide for dustbin replacement.

  1. KLsHqkt2ytgfFNrP
    KLsHqkt2ytgfFNrP
    lLP6NkfiLIyVcdZp
    1rJEOJDKo4joYBs5
    • Unclip the plastic band from the vacuum head.

  2. FucFvBCJHA6BcghP
    FucFvBCJHA6BcghP
    LMOXwRZu5mTjsDeB
    • Remove six 6 mm screws using a Phillips #0 screwdriver.

  3. BNbPHZpgqkFOQwHh
    BNbPHZpgqkFOQwHh
    duOwIcUKXhe4jBiG
    • Remove the vacuum head guard.

  4. 63AHtWLMfOvgbqsX
    63AHtWLMfOvgbqsX
    rCMlhMc3KyMrcECm
    • Remove the ten 4 mm screws using a Phillips #0 screwdriver.

    • There are five screws on each side of the vacuum.

    Maybe add circle indicators, because in the photo there's 5 holes.

    Ryan Muscove -

  5. lAo4t1oYgSC2RIFh
    lAo4t1oYgSC2RIFh
    HG1APG5wLWrduqlW
    • Remove the single 4 mm screw from the circuit board using a Phillips #0 screwdriver.

  6. sd6nFvlVub5YcHt6
    sd6nFvlVub5YcHt6
    WAWDXnUTTu1eakEn
    • Unfasten the remaining clips.

  7. PSgUIpVMT5ORDxmQ
    PSgUIpVMT5ORDxmQ
    RaSHWQShmsQHVlkN
    GMVlJALFX25ZkM5c
    • Remove the dustbin.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Siaosi Kaufusi

Member since: 12/09/23

661 Reputation

0 comments