Husqvarna FE 350 Rear Sprocket Replacement

Written By: Bryce Marking
  • Comments: 1
Husqvarna FE 350 Rear Sprocket Replacement

Difficulty

Moderate

Steps

9

Time Required

45 minutes - 1 hour

Introduction

If you need to replace the rear sprocket on your Husqvarna FE 350, follow this step by step guide. Be sure that the bike is off prior to beginning this repair. You will need a bike stand to do the repair and potentially a helper to place it on the stand.

  1. ExfPwBKgZWkd5Qhc

    • Place the motorcycle on a stand so that the rear tire is off the ground.

  2. Ugu3he5mXcPXU2gJ
    Ugu3he5mXcPXU2gJ
    qNP5ptKOvP4OL5TY

    • Use the 27mm wrench to unscrew the nut that holds the axle together. This nut is located on the right side of the motorcycle at the end of the swing-arm.

  3. OrPGOXFQe2JriSee
    OrPGOXFQe2JriSee
    bPohPV4qd5eAICnA
    SoDpGMAKlTbmMDMY

    • Move to the left side of the motorcycle and remove the axle by pulling it directly out.

    • Move back to the right side and remove the spacer shown in the third picture to ensure that is does not get lost.

  4. 4iUrYSOrGXGKLNJL
    4iUrYSOrGXGKLNJL
    fJpKUs3oQrWcX56E

    • Pull up and back on the chain to free the tire.

  5. W1rQXgWsnORURcSu

    • Lay the tire on a flat surface with with sprocket facing up.

    • Use the 6mm Torx wrench to unscrew the six bolts holding the sprocket on.

    • Replace the sprocket and screw the bolts back in.

  6. SnkN6Zn2LmL2KET6

    • Be careful that the brake rotor fits in between the brake pads on the caliper.

  7. vrd6omn3TjBtbXCh

    • Put the chain back on. Start at the bottom and work the chain carefully over the top of the new sprocket.

  8. mF4SygNWESeKxfAx
    mF4SygNWESeKxfAx
    3aaOYR5IYBVN1mjW
    CsXOWRsAqvNg6bTd

    • Push the axle back through the swing arm and the wheel.

    • Place the spacer back onto the axle with the square side pointing forward.

    • Thread the 27mm nut back onto the axle.

  9. wFrQu4LFwa6mrj4G

    • Use the 27mm wrench to tighten the nut down.

Author

Bryce Marking

Member since: 02/02/21

231 Reputation

One comment

C'est bien. je veux apprendre à réparer les motos

Enoch DEMBELE -