How to remove and clean the Dyson DC14 filter

Written By: Donald Percivalle
  • Comments: 1
How to remove and clean the Dyson DC14 filter

Difficulty

Easy

Steps

3

Time Required

10 - 15 minutes

Introduction

The filter on the Dyson DC14 vacuum needs to be cleaned every six months in order to maintain its peak operating condition.

  1. x25tLUeUIWJajnEZ

    • The filter is located in the canister of your vacuum.

  2. 6qqsJaKpIfINQlKZ
    6qqsJaKpIfINQlKZ
    XIvCm1qNxYR2GrqF
    gHYCfUSEREkMy5Ro

    • Open the canister filter compartment. Push the clip upwards, and open the canister top away from you.

    • Remove the yellow filter housing.

  3. 2TKaygY1nnDCb3bu

    • Remove the blue sponge-filter from the yellow filter housing.

    • The filter and housing must both be completely dry before reinstalling. Do not use your vacuum without filters installed.

    • Clean the blue sponge-filter in cold water until the water runs clear.

    Do i need to keep the filter into sun light so it can be dry out complete? or only should keep it for 1 hour in shadow would do

    Rao Yousaf -

Conclusion

Once the filter is cleaned, set the blue filter sponge and the yellow filter housing aside for at least 24 hours to dry. Do not use your vacuum without a filter, or when the filter is still wet. To reassemble, follow the steps in reverse order.

Author

Donald Percivalle

Member since: 03/10/12

1923 Reputation

0 comments