Introduction

Have you noticed a snag or loose thread in one of your embroidery pieces? Don't get rid of it! This step-by-step guide will help you repair it. It is such an easy fix that only takes a few steps using the right tools.

  1. EuTQEvbiCwWptIFY
    • Gather all the necessary materials for your fix following these guidelines:

    • Pick the proper embroidery needle size. Lightweight fabrics can use a smaller needle, while heavyweight fabrics will need a larger needle.

    • Ensure that you pick a color of embroidery floss that matches the color of the thread you are trying to fix.

    • If using a lightweight fabric (e.g. cotton), use an embroidery hoop to stabilize the fabric.

  2. SghP3t2T2WfxKTSv
    SghP3t2T2WfxKTSv
    cuQveJJYMS56b1Ad
    DQjbTXebtuFZ5G3Y
    • Embroidery floss consists of six different strands.

    • Separate the strands and decide how many you will need to thread.

    • Pull the strand(s) through the eye of the needle and ensure that the needle is in the center of the strand(s).

    • You should have double the amount of floss once threaded than when separated.

  3. wdCoMr5jnNYeZfSv
    wdCoMr5jnNYeZfSv
    uJbIOLKbhehQTedD
    opUGjCrxIQMRHvL4
    • To tie the floss, wrap the end around your pointer finger three times.

    • Slip the wrapped strands off your finger, and then pull the needle through the center.

    • Pinch your fingers where the longest part of the strand meets the wrapped portion and pull towards the end of the thread.

    • This should form a messy knot.

  4. SEwWoCjQkaLieIEX
    SEwWoCjQkaLieIEX
    JfTQVJdPGLi4AuQN
    • Pull the needle and thread through the fabric as close to the loose thread as possible.

    • Push the needle and thread down through the other end of the loose thread.

    • Repeat these steps 3 to 4 times going over the thread until it becomes flush with the rest of the embroidery pattern.

    • Be aware of where your hands are located while using the needle.

  5. RUhRsSEruBEPTSCv
    • To tie the anchor knot, push the needle and thread through an existing stitch or fabric hidden under the pattern. This should form a loop when you pull the needle.

    • Place your needle through that loop and pull to create an anchor knot.

    • Repeat this step 1-2 times to strengthen the knot.

  6. YZYLlPEEC1ZJJFMH
    • When the knot is finished, the thread should be completely flush with the rest of the embroidery pattern.

  7. HXPnvPGxAEK6DmcI
    • To strengthen the embroidery you may use either fabric glue or a steamer. If you are using a lightweight fabric, make sure you use an embroidery hoop.

    • To use fabric glue, apply 1-2 drops everywhere that there is embroidery on the back of the fabric. Allow this to dry for at least 5 minutes.

    • If using a steamer, follow the instructions to turn it on for your particular model. Run the steamer over the back of the fabric two times. This will make the stitches taut.

    • Test the steamer first on the fabric in a hidden area before steaming to avoid staining or burning your work.

Samantha Cook

Member since: 27/09/23

145 Reputation

0 comments