How to Clean a Dirt Devil Vacuum Cleaner Roller Brush

Written By: Minji Choi

Comments: 6

How to Clean a Dirt Devil Vacuum Cleaner Roller Brush

Difficulty

Easy

Steps

Time Required

20 minutes

Introduction

This guide is for users who are unfamiliar with disassembling the Dirt Devil Vacuum Cleaner model. This includes the basic steps on how to disassemble the vacuum model, clean the roller brush, and reassemble the vacuum. These simple instructions are for users who have a problem with the vacuum roller brush not spinning and want a quick repair on their own. The special requirement of this guide is to know how to loosen the screw on the bottom plate and tighten the screw.

Tools

Step 1

Lay the vacuum cleaner on the floor so that the bottom of the vacuum is facing upwards.

Step 2

Use a Phillips head screwdriver to remove eight screws.

This one only has six screws

Claudia's Place -

Step 3

Disassemble the vacuum head and pop out your roller brush.

I cannot disassembled ahead it seems to be stuck. How do I disassemble if I already took the screws off

Claudia's Place -

Step 4

Cut the ends with scissors.
Cover the floor with papers to prevent debris and hair from falling on the ground.

Step 5

Use a brush to clean the roller brush.

Step 6

Put the rectangular part on both sides.

Step 7

Check if the belt is attached.
Check if the motor part is well inserted with the belt attached to the roller brush.
Make sure the shape of the motor fits to prevent it from falling.