How to Change the Oil for the Honda EU2200IT A2

Written By: Arthur Shi
  • Comments: 0
How to Change the Oil for the Honda EU2200IT A2

Difficulty

Easy

Steps

8

Time Required

No estimate

Introduction

This guide shows how to change the engine oil for the Honda EU2200IT generator. This procedure is a prerequisite for many other repairs.

Oil specifications:
SAE 10W-30
0.46 US quarts (0.44 L)

  1. 2RcWcdXnpuMICOPf

    • Before you begin, make sure the generator is switched off and the generator is cool to the touch.

  2. 4pUWZSMoPDsUsmgB
    4pUWZSMoPDsUsmgB
    ovqPPHBsYDOyPTWB

    • Lift and remove the spark plug cover.

  3. LBekvfGNewVuFSmt
    LBekvfGNewVuFSmt
    GSUCKM2i6mTB6bAt

    • Grab the plastic housing at the end of the spark plug wire.

    • Pull firmly to disconnect the wire from the spark plug.

  4. OHs3UlmVblBpcMIe

    • Use a Phillips #2 screwdriver to loosen the screw holding the maintenance cover in place.

  5. aTiAjAVTQqrOBmJd
    aTiAjAVTQqrOBmJd
    3FVmFTPjDxllE1XA
    qWOoL4xyWLOLq3vO

    • Swing the top of the maintenance cover out.

    • Remove the maintenance cover.

  6. 6dyxXaqnwLNMTxdR
    6dyxXaqnwLNMTxdR
    3cxmFoMqPHLX6TBj

    • Unscrew and remove the oil filler cap.

  7. RACSGqrK6SIjYqaP
    RACSGqrK6SIjYqaP
    MDLqFiZsmpfKVJrp

    • Place an oil pan below the fill port to catch the engine oil.

    • Carefully tilt the generator towards the oil pan to drain the oil.

  8. RlqldmCjgs5iDnk1

    • During reassembly, be sure to refill the engine oil:

    • If you recently resealed the crankcase cover with liquid sealant, wait at least 20 minutes before adding oil.

    • Use SAE 10W-30 oil, up to 0.46 US quarts.

    • Add oil until the dipstick is almost completely submerged.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Arthur Shi

Member since: 03/01/18

248651 Reputation

0 comments