Hover-1 XLS Battery Replacement

Written By: Jonathan Hidalgo
  • Comments: 7
Hover-1 XLS Battery Replacement

Difficulty

Moderate

Steps

2

Time Required

5 - 10 minutes

Introduction

If the bike is not performing at its maximum capability, its battery may be corroded, and you should replace it as soon as possible. Before beginning this guide, you will need power tools or a chemical remover to deal with Teflon tape on the screws.

  1. UZsemWZZY2FOVMLr
    UZsemWZZY2FOVMLr
    s3WxGhyYbSUch3Tv
    qGCqs4aHTDbCegsB

    • Remove the four, 12mm Hex #3 screws located on the bottom half of the battery compartment.

    • There are four screws that need to remove. Two on one side and the two on the opposite side.

  2. JSb6AdcrFKVIt1Ab
    JSb6AdcrFKVIt1Ab
    PmrZOnKQF2lETsGU
    FkyKgYDiwJZpS24j

    • Remove the adhesive holding the wires tightly.

    • You can use a sharp object to score the adhesive before pulling.

    • Pull on both sides of the wire connections.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Jonathan Hidalgo

Member since: 24/01/19

575 Reputation

7 comments

That looks easy enough to do. My problem is finding a replacement battery. Do you have any idea where they are available?

David Schultze -

David did you happen to find one? Please let me know I've been looking for one

Michael Hawk -

If anyone find a 1:1 replacement battery for this, or at the very least a wiring diagram, please post it as it's near impossible to find anything on this thing in 2022.

GutZ Era -

Hi, where can you find the battery replacement? I have my scooter and the battery needs to be replaced.

Mary -

has anyone been able to find the battery replacement ? any links ?

Fabulous P -

I agree 100% dam Battery is impossible to find with the same Plugs

Mike Jones -

Cannot find a battery ANYWHERE. Looks like I'm replacing the scooter with a more reputable brand like Segway

skyyballer -