Hover-1 XLS Back Seat Light Replacement

Written By: Christian Roberts
  • Comments: 0
Hover-1 XLS Back Seat Light Replacement

Difficulty

Easy

Steps

4

Time Required

3 - 6 minutes

Introduction

A broken light on a Hover-1 XLS bike is a safety hazard, especially if you use the bike when dark. Do not ride the bike with a broken tail light.

  1. GWAZYRKphFDk3UAt
    GWAZYRKphFDk3UAt
    R1wEJx6UyWkHff2N

    • Remove the seat by removing the six 16mm screws with a Phillips #2 screwdriver.

    • Remember that the seat is still connected by the wiring once you unscrew it. Pulling too hard can damage the connector.

  2. jsNuhtndseONIJS1
    jsNuhtndseONIJS1
    SjJaMafJFkSDGdfH
    mG2UAPOK5GLwwwpU

    • Disconnect the wires by pushing the levers on either side of the connector and on top.

    • Remove the seat from the bike.

  3. KdyZnasYsHeAIsqm

    • Use a Phillips #2 screwdriver to remove the four 10mm screws on the bottom of the back seat.

  4. TUIDBoHqMedS1MMZ
    TUIDBoHqMedS1MMZ
    dor1ypeAwWOdmOLR

    • Pull the light from behind the bottom of the seat frame. Pull the wiring all the way through.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Christian Roberts

Member since: 24/01/19

248 Reputation

0 comments