Hover-1 Maverick Motor Wheel Replacement

Written By: Piper Feldman
  • Comments: 0
Hover-1 Maverick Motor Wheel Replacement

Difficulty

Moderate

Steps

6

Time Required

30 minutes

Introduction

This guide for the Hover-1 Maverick guides users in replacing the motor in their device. The motor is crucial within the hoverboard. It converts energy in order to allow the device to move. Symptoms of having a faulty motor include the device not being able to move or it has flashing lights. Users will need to disconnect the battery along with wires in order to replace the motor.

  1. 2vugCAUUbpwBLRq3
    2vugCAUUbpwBLRq3
    TsSGUyCpMh4ppKWx
    LMt3CTWEUl1vi4y5

    • Remove the twenty 15mm Phillips #1 screws from the shell of the hoverboard.

    • Open the shell.

    • There is one motherboard on each side of the device located near the wheels.

  2. F2HR6vpgBEFyQWCS
    F2HR6vpgBEFyQWCS
    bBcVaiIT1mtbtrKo

    • Disconnect the battery to prevent any electrical currents from coming through the wires.

  3. JNu4LYGqZgKBlIWy
    JNu4LYGqZgKBlIWy
    HMvbNX1xFYQGMZ1V

    • Squeeze and pull on the wires to detach them from the motherboard.

  4. l1o2fOoXwogs5ylh
    l1o2fOoXwogs5ylh
    rFIdYrOP5PlPvVIX

    • Remove the four 8mm Phillips #1 screws.

    • Remove the motherboard from the device.

    • Repeat for the other motherboard.

  5. xbWfOMYJxeuyXTFA
    xbWfOMYJxeuyXTFA
    CwiL1IKGZPitJViu

    • After the motherboard is removed from either side, remove the four 15 mm hex screws with a 5mm Allen wrench.

    • Remove the metal covering from over the motor.

  6. ooTCxQhkGWLvGAFU

    • The motor is attached to the wheel, so in order to remove the motor, you must take out the entire wheel.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Piper Feldman

Member since: 23/01/20

409 Reputation

0 comments