Hover-1 H1 Charging Port Replacement

Written By: Madeline David
  • Comments: 1
Hover-1 H1 Charging Port Replacement

Difficulty

Moderate

Steps

8

Time Required

30 minutes

Introduction

Replacing the charging port of your Hover-1 H1 hoverboard will help to solve charging problems.

  1. CnWFkk1BJPRa2Lio

    • Remove the ten 9mm machine screws by using a long Phillips #2 screwdriver to rotate the screws counterclockwise.

    • Remove the twelve 9mm sheet metal screws by using a long Phillips #2 screwdriver to rotate the screws counterclockwise.

  2. ZkCHDORttn6GSQOh

    • Puncture the two black stickers by using the tip of a screwdriver.

    • Remove the two 9mm machine screws by using a long Phillips #2 screwdriver to rotate the screws counterclockwise.

  3. VjDfPrZd2XnstwhP
    VjDfPrZd2XnstwhP
    FXuOfl4YUAdC46C3

    • Lift each side of the bottom shell by pulling up.

    • When lifting the shell, take care to not tear any cables from their connectors.

  4. WvblXP2vPSkx1HPx

    • Unplug the battery by pulling gently on both sides of the orange connector.

  5. HqNhtQOldSceluXy
    HqNhtQOldSceluXy
    uMnp3ldkGA1uRfsE

    • Using a utility knife, scratch off the hot glue from the connector attaching the red and black wires to the motherboard.

    • Be careful to not damage the wires or connector when removing the glue.

  6. YULTQQoNEe6PJP3h

    • Remove the charging port connector from the motherboard by squeezing the connector and pulling the connector up.

  7. 1P3TkWEQ4QfNkeAM
    1P3TkWEQ4QfNkeAM
    DQJTOHpYfFKxW4X1

    • Using an adjustable wrench, unscrew the nut that is attaching the charging port to the bottom shell.

    • It might be helpful to put the charger in the charging port while unscrewing the nut to ensure that the port is not spinning.

  8. fOQkVw3ECfIPtGEU
    fOQkVw3ECfIPtGEU
    bC1DOXI1umWPNGmD

    • Pull the charging port to the left through the shell.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Madeline David

Member since: 08/10/18

274 Reputation

One comment

I need to replace the charging port on my H1 hoverboard. Can you share the link for the actual replacement part.

prdrngga -