Hoover Windtunnel Air Steerable Upright Motor Assembly Replacement

Written By: steven hoover
  • Comments: 1
Hoover Windtunnel Air Steerable Upright Motor Assembly Replacement

Difficulty

Moderate

Steps

6

Time Required

7 minutes

Introduction

This guide will help assist you with removing and replacing the motor assembly in your Hoover UH72400.

  1. cW2iejGICigXxgWw
    cW2iejGICigXxgWw
    uJsDpFhiU5cRjSKH

    • Put the cleaner into the upright position, turn the power off, and unplug the power cord.

  2. V1RDd2wlXCChyb3p
    V1RDd2wlXCChyb3p
    B5Ys6BDGScngiiEp
    BOq5PUJGRMvPj6HM

    • Remove the dirt cup from the cleaner.

    • The HEPA filter is located under the dirt cup and under where it says HEPA.

    • Twist the top counterclockwise to unlock the cap.

  3. km5VE4mSboUNF2uq
    km5VE4mSboUNF2uq
    iMY21OD6aZxCwJYo

    • Lift the HEPA filter out.

    • Tap the filter against the inside of a trashcan to knock out the dirt and debris or replace as necessary.

    • Do not wash the HEPA Filter.

  4. VGaTe5A2DngBG63q
    VGaTe5A2DngBG63q
    YbIN2DmosSBtb5Ny
    mR1m1pNknVuGKIwJ

    • Remove the 4 retaining screws and remove the filter tray.

    • Screw lengths are approximately 3/4".

  5. vopXBAFBPsBGA3MS

    • Pull the motor housing vertically to dislodge the motor.

  6. hhgJONEPjS3FGkwN
    hhgJONEPjS3FGkwN
    LQLY5scxK5RsvXXA
    1NDrDSdbEhJ4MLgr

    • Use a plastic spudger or opening tool to press on the small circle and wiggle clips free.

    What is the connection called that goes from the motor wire to red and white cables mine broke and I need a new cable like that one

    Jay F -

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

steven hoover

Member since: 27/09/17

257 Reputation

0 comments