Introduction

Brush rolls are made to move at high speeds in order to pick up dirt from carpet and wood floors. Sometimes the brush roll can get clogged or break. Follow this guide for brush roll replacement.

  1. KeZCJwJCvrDUAH4L
    KeZCJwJCvrDUAH4L
    mPnTClHAFHW6eCZF
    • Press grey release button on stick vacuum to release vacuum head.

  2. EbGLHmnDcHaPMyxE
    EbGLHmnDcHaPMyxE
    Aa42BSoFUkZM6bml
    F3WjWQEqbbADQuIN
    • Locate the circular black turn switch, which is in the upper right corner of the backside of the vacuum head

    • Using a metal spudger, place the tool in the indent of the circular turn switch and turn it from the left to the right or from the "locked" symbol to the "unlocked" symbol

  3. H66Shpm62jpJREoM
    H66Shpm62jpJREoM
    q3UaNvnRQ3urGVcL
    • Flip the vacuum head over so that the wheels and screws are facing you.

    • Using a PH #1 screw driver, remove the four 15mm screws from each corner of the backside of the vacuum head.

  4. tVNER3nJBKBLWaAE
    tVNER3nJBKBLWaAE
    6F4APtO4PMCODeJY
    tRcVy36MNHCcJKjC
    • Locate the two wheels in the upper half of the vacuum head and remove them by sticking the metal spudger tool underneath the wheel and pushing it towards you until it pops out.

    • Remove the two 15mm screws located under the wheels with a PH #1 screw driver.

  5. AvL5xUwbH1kGYSgY
    AvL5xUwbH1kGYSgY
    3OW1HYaYMDcjwNEx
    eJxuMsQxpboRphar
    • Using a firm grip, pull the two halves of the vacuum head away from each other until they are completely separated

  6. fdX1GFhhL1KmE1it
    • Remove brush from inside the vacuum head.

Conclusion

To reassemble your device, follow these instructions in reverse order.

katia zubieta

Member since: 11/09/17

437 Reputation

0 comments