Hamilton Beach 25460Z Plug Wiring Replacement

Written By: Maxwell Taylor
  • Comments: 1
Hamilton Beach 25460Z Plug Wiring Replacement

Difficulty

Easy

Steps

5

Time Required

5 - 10 minutes

Introduction

This is a straight-forward process that requires removal of a few screws and two wire caps.

  1. eieudpyoAhpknDnD
    eieudpyoAhpknDnD
    JRyq1dJjV14dtnMW

    • Unplug your device before proceeding with disassembly.

    • Remove the four 14mm screws from the bottom of the Panini Press using the T10 Screwdriver.

  2. sAtRmk2nR3BjSnJV

    • Lift up the plastic cover to expose the plug wiring.

    • Mark the plug wire connected to the red wire with a piece of tape. This will be used as a reference for reassembly.

    it doesn't matter red or blue it's just AC power

    Qatra -

  3. gMaWRjlU1b3tjRcK
    gMaWRjlU1b3tjRcK
    nNqWuYHuqm5F3DFI
    Z2Q12CIWGMN4vqum

    • Use the pliers to pinch the widest point of the cap. This should be done opposite of the already existing crimps.

    • Slide off the white cap.

    • Repeat these steps for the second white cap.

  4. 4vhXfQ3RMYLlPhKj
    4vhXfQ3RMYLlPhKj
    Kc2wLRGImKWkGdAs

    • Remove the two rubber screw covers from the bottom of the Panini Press.

    • Remove the four uncovered 10mm screws with the PH2 Screwdriver.

  5. LQpvH5f3GGAR3LV6
    LQpvH5f3GGAR3LV6
    HyMFBRfEXh5eMlGc

    • Lift the plastic lower heating element up and place to the side for reassembly. You have now disconnected the plug wiring completely.

Conclusion

To reassemble your device, follow these instructions in reverse order. Make sure to correctly replace the wires using tape you placed earlier as a reference.

Author

Maxwell Taylor

Member since: 09/02/15

149 Reputation

0 comments