HTC Maple 100 Back Panel Replacement

Written By: Andrew Van Meter
  • Comments: 0
HTC Maple 100 Back Panel Replacement

Difficulty

Moderate

Steps

6

Time Required

8 minutes

Introduction

Remove 4 Torx screws and 2 #00 Philps

  1. PKkyHk6a35BflpJu

    • First remove the back cover of your phone to expose the battery.

  2. TCKDYrGcG3UBUgTo

    • Turn the phone over.

    • Push forward on the battery with your thumb.

  3. pP4DmaEn62Ivptpt
    pP4DmaEn62Ivptpt
    uA133yAWUvYoACQo

    • Take the battery out by lifting it upwards.

    • When reassembling, make sure that the battery contacts match up.

  4. lJZHrQRlFLXqKWcq
    lJZHrQRlFLXqKWcq
    l5phqTa6LZXHNGle

    • Remove the four 4.9mm T6 Torx screws that secure the back panel to the rest of the phone.

  5. ndMdNR1SBwusvWDy

    • Remove the two 4.3mm Phillips #00 screws that secure the back panel to the rest of the phone.

  6. BLXJo3ZImBNT1yiU
    BLXJo3ZImBNT1yiU
    qe6eGBCayevDQPcW
    TVELAuQprIUPwGGA

    • Insert the plastic opening tool along the seams at different points to it pry the clips off.

    • This may require a bit of force. The USB port cover may fall off in this step.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Andrew Van Meter

Member since: 06/10/11

24 Reputation

0 comments