HP ProOne 600 G1 Prerequisite only

Written By: Maxwell Snook
  • Comments: 0
HP ProOne 600 G1 Prerequisite only

Difficulty

Easy

Steps

4

Time Required

5 minutes

Introduction

Back Removal.

  1. vcNPplHdEXWAsNDu
    vcNPplHdEXWAsNDu
    jeYdHvufghaDW4LV

    • Push the unlock tabs on the back of the monitor in and towards each other while sliding the back cover up.

  2. L4vXccDFMw45kHQw
    L4vXccDFMw45kHQw
    WcZNIweZRBPZBgA4

    • Loosen the two 1/2" screws , with the T15 Torx Screwdriver, on each side of the stand. Remove stand.

  3. NL5JCmIVFVvb6C1U

    • Take out the single 3/8" screw, with the T15 Torx Screwdriver, from the middle of the backplate.

  4. 6fEjQud3xLXXebwP

    • Remove the backplate by pulling it back towards you.

    • Small plastic tabs hold in the backplate, pull these up to remove it.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Maxwell Snook

Member since: 01/10/15

221 Reputation

0 comments