HP Officejet Pro 8620 Power Adapter Replacement

Written By: Scott
  • Comments: 2
HP Officejet Pro 8620 Power Adapter Replacement

Difficulty

Moderate

Steps

8

Time Required

15 minutes

Introduction

This guide will help you replace your power adapter inside the printer.

  1. RPcMBEMORxtB2Knn
    RPcMBEMORxtB2Knn
    OlWrGWjmHQ3DaPeQ
    FSMmi45ynO6BmnXM

    • Turn off the printer and remove the power cable.

    • Remove two 13mm T9 screws using a T9-Torx screwdriver. Turn counterclockwise until the screws are released.

    Apparently screws are T10 not T9. T9 driver/bit works, but you'll slightly damage the screw. I use a T10 now.

    dbovey -

  2. ofGfAiDWFE2nktId
    ofGfAiDWFE2nktId
    tGZB4KSMNSerlv2c

    • Open the front door by placing your finger on the indented groove on the left side of the printer and pulling down

    • This will give you access to the two T9-TORX 13mm screws that need to be removed to release the panel.

  3. IjeZiOU2oXX12tYU
    IjeZiOU2oXX12tYU
    WbsePD313KNuNcvj

    • Remove the two 13mm screws with a T9-TORX screwdriver by turning counter-clockwise (left).

  4. cB2FBK3wOoRKuWDU
    cB2FBK3wOoRKuWDU
    JsLhDjFN1OcPhTrX
    ZmrOEAq5IC1PJnwi

    • Gently remove the left side panel by placing your palm flat against the surface and pulling down.

  5. Y2qmwRoVqdjKxoag
    Y2qmwRoVqdjKxoag
    RDixejjL12cvt4SM
    LkpWNxBCYg3QLNSi

    • Remove two screws 13mm screws with a T9-Torx screwdriver by rotating them counterclockwise.

  6. cRVbJcuUUrt2JRwW
    cRVbJcuUUrt2JRwW
    skNtZRpRSEd1xdAW
    oYRrVaRYDONC2eCn

    • Unplug the black cable .

    • Move all the cables and wires to the top of the motherboard to allow the power adapter underneath to be removed freely.

  7. HKmiAWP1K1uCXdQt

    • Gently bend the black ribbon cable.

    • Remove one 8mm T8 screw underneath the ribbon cable by rotating it counterclockwise with a T8 -Torx screwdriver.

    • Take out the black plastic cover and the colored wires connected to it.

    • Now you have cleared a passage for the power adapter to be taken out.

  8. RXiMA1AnluL3sX2a

    • Gently pulling out the power adapter.

    • Be careful with all the wires when pulling out the adapter.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Scott

Member since: 24/01/18

593 Reputation

0 comments