HP Mobile Thin Client mt41 Back Cover Replacement

Written By: Raul Rodriguez
  • Comments: 0
HP Mobile Thin Client mt41 Back Cover Replacement

Difficulty

Moderate

Steps

6

Time Required

15 minutes

Introduction

  1. LJXOEPU3ETlV2oEm

    • Locate the two slots on the bottom of the laptop to unlock the battery.

  2. el3ZicfHugSpDvyO
    el3ZicfHugSpDvyO
    cITJqKj3yttdmDHI

    • Pull on both slots outwards as shown in the images to unlock the battery. The battery will not come out if the slots are locked. The battery should easily slide out without much force.

  3. gaKXdvnfM2OsI6ij
    gaKXdvnfM2OsI6ij
    uAVmpHHsBtABBMEc

    • Remove the nine screws that keep the back cover secured using the T5 Torx screwdriver.

  4. mvbymSGJsjfXjQYi
    mvbymSGJsjfXjQYi
    WV1RlRyQXdVdft1k

    • Remove the middle plate using the iFixit opening tool.

    • This may require a bit of force. If it is not coming out try the other side.

  5. oZvwcB3XXQ3QksYc

    • Pop the back cover off from its latches by separating the two parts along their seam using the iFixit opening tool.

    • Be gentle; the plastic can crack.

  6. U2DHXUTBKPYnNEHN

    • Lift the back cover once all corners are unclasped from their latches.

    • Lifting the cover should not require much force.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Raul Rodriguez

Member since: 27/02/18

289 Reputation

0 comments