HP Mini 1000 RAM Replacement

Written By: Walter Galan
  • Comments: 1
HP Mini 1000 RAM Replacement

Difficulty

Easy

Steps

5

Time Required

5 - 10 minutes

Introduction

Use this guide to replace or upgrade the single PC2-4200 RAM stick on your Mini 1000.

  1. NlpLgN4cG3NHRYVi
    NlpLgN4cG3NHRYVi
    MQhnkA31HbymZ4wU

    • With the case closed, place the Mini 1000 top-side down on a flat surface.

    • Push both of the battery release latches toward each other.

  2. NZ5Q6JEwcTdPOkRi

    • Lift the battery out of the Mini 1000 from the edge closest to the release latches.

    Need a battery and a keyboard.

    valfin.teach -

  3. wsLvXYFAcJ3esbnB
    wsLvXYFAcJ3esbnB
    QCHwtFkhcTComsut

    • Before proceeding, slide the right battery release latch to the unlocked position nearest the center of the computer.

    • Use the tip of a spudger to slide the RAM compartment cover release latch away from the center of the computer.

    • At this point, the edge of the RAM compartment cover nearest the battery compartment should pop up from the lower case.

  4. UyVi3EervheQPBUE

    • Remove the RAM compartment cover from the lower case.

  5. WyZLMmo2JoVCJUjN
    WyZLMmo2JoVCJUjN
    hOBhUf11QrkQeiwl

    • Use your fingers to simultaneously pull both RAM retaining arms away from the center of the RAM chip.

    • The RAM chip should pop up slightly from its socket.

    • Pull the RAM chip out of its socket and remove it from the Mini 1000.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Walter Galan

694047 Reputation

0 comments