HP LaserJet P1102w Left Side Panel Replacement

Written By: Jerome Etten

Comments: 3

HP LaserJet P1102w Left Side Panel Replacement

Difficulty

Moderate

Steps

Time Required

10 - 15 minutes

Introduction

These steps will show how to replace the left side panel from the printer. This prerequisite guide will be used for the power plug removal, motherboard removal, and half of the drive belt removal guides.

Tools

Step 1

Flip printer on it's back. Using the plastic spudger, pry off front panel. There will be two main points to focus as shown.
Pry carefully to not break any plastic.

my two main points were precisely under the rubber feet, they were surprisingly difficulty to dislodge.

Peter Taffs -

Step 2

Now that the pry points are free lift up the front panel.

Step 3

Unscrew the #1 Phillips screw 6mm on the back of the printer.

Step 4

Using the plastic spudger, remove the button housing from the top left of printer.
Pry carefully to not break any plastic.

Step 5

Once the housing is removed, remove the three buttons.

Step 6

Use the plastic spudger to remove the side panel. There are three main prying points as shown.
Pry carefully to not break any plastic.

mine had a PH2 screw on the printer back thru the side panel into the aluminum serial plate/back, placed in the 2nd and third picture in the tab with a round screw hole and square locator hole. Critical clips were center back, center top and center bottom, and two points on the front.

Peter Taffs -

edit, i see the screws talked about in step 3. sorry.

Peter Taffs - 04/01/24