Introduction
This guide is meant to show you how to replace a broken, malfunctioning, corrupted or otherwise inadequate drive. This guide requires a small amount of technical knowledge and is considered a moderately easy guide. There are no hazards associated with this guide, but it is vital to keep track of all the small parts that are removed during the process.
-
-
Place the computer screen down on a flat surface.
-
Push the two locking latches to the unlocked position.
-
Push the cover toward the top of the computer and lift up.
-
-
-
Grasp the handle on the hard drive cage to the left of the stand. It is marked with green.
-
Pull the handle up, allowing the entire cage to slide toward the outward edge of the computer.
-
Pull the entire cage up and out of the device.
-
-
-
Once the cage is out of the device, use a Torx T15 driver to unscrew the four 10mm screws keeping the drive in place. There are two screws on each side.
-
Once all the screws are removed, lift the drive out of the cage.
-
To reassemble your device, follow these instructions in reverse order.
2 comments
where can i buy a replace cage for the hard drive?
What replacement guide can I buy for my HP EliteOne 800 G1 all in one?