Introduction

Use this guide to replace the fan on the HP Elitebook 1040 G4. The fan is essential for expelling heat away from the laptop and keeping the hardware running smoothly. This prevents computers from overheating, shutting down, and damaging components. The fan may be producing excessively loud noise or creating an odd smell which may indicate the fan needs replaced. Although the fan can be replaced without removing the battery, we advise removing the battery before you begin to ensure safety and avoid any electrical issues.

To complete this guide, you will need a #T5 Torx head screwdriver and a Philipps #0 and #00 screwdriver.

Before beginning, be sure to completely power off your computer.

  1. OwRelP1Q2kdGOtoE
    • Use a T5 Torx screwdriver to remove the eight 5 mm screws securing the back cover to the chassis.

  2. 6TZHI6LLpl1SrHDP
    6TZHI6LLpl1SrHDP
    Xt1FHAqjNTIryfDn
    • Lift the back cover up and off the device.

  3. MRTdDBqBg2Tq6KUi
    MRTdDBqBg2Tq6KUi
    svSIJTjy3iOkuIdL
    • Using the Phillips #0 screwdriver, remove the two silver 5 mm screws surrounding the fan.

    • The top left screw may be hidden under shielding tape.

  4. qknqXccFeatLT2jH
    qknqXccFeatLT2jH
    P6HWMiLDLUCSOSKY
    3CmxU2EPuFHExN6d
    • Remove the electrical tape to expose the heat sink screws.

    • Using the Phillips #0 screwdriver, unscrew the four screws securing the heatsink to the motherboard.

    • Carefully disconnect the pin connector by pulling it from its slot.

  5. lVSSdwDL1Yuy4taD
    • Carefully remove the wires from the clip to the left of the fan.

  6. UlNRUKs6ZYmOyEFF
    UlNRUKs6ZYmOyEFF
    nwwvgw2LHYxYjph5
    • Lift and remove the fan and heatsink assembly from the device.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Hannah DiMartino

Member since: 28/09/21

395 Reputation

0 comments