Introduction

Screens can become damaged in many ways. This guide will help replace the screen.

  1. OyN6UkEpUvBHjXaH
    OyN6UkEpUvBHjXaH
    iRZK1Frc4eUldwxQ
    6xmBtXVTCqSPw1IL
    • Wedge the spudger between one of the black rubber caps on each of the four corners on the bottom of the HP Chromebook 11-v011dx.

    • Lift up the black rubber cap until it is completely removed.

    • Repeat this until all four of the black rubber caps are removed.

  2. LtyRSaAIguaiGZwJ
    LtyRSaAIguaiGZwJ
    DJOtmKcwGmGRL2c5
    • Locate the two smaller black rubber caps on the top corners of the HP ChromeBook 11-v011dx. Wedge the spudger between one of them.

    • Lift up the small black rubber cap until it is completely off.

    • Repeat this step one more time to remove the other small black rubber cap on the other side.

  3. Vj4nnDASXAJaqNZh
    Vj4nnDASXAJaqNZh
    RZoX5uUOrQDRbJQ3
    • Locate the eleven screws on the bottom the HP ChromeBook. Six are located under the larger black rubber caps and the others are in different locations.

    • Use a Phillips #0 screwdriver to remove eleven 1.3mm screws.

  4. 5WKSJNIUdMvRylYw
    5WKSJNIUdMvRylYw
    cXvWanB6pCqWRDRS
    1KTh6YlTQRJOFVA5
    • Make sure to do steps 1-3 or it will be impossible to lift up the key board and you may also do damage to the hardware.

    • Wedge the spudger between the key board and the bottom panel, carefully go around the keyboards edges gently.

    • Lift the spudger a little in the front of the keyboard until the key board lifts up.

    • With your hands, slowly and carefully lift the key board up.

  5. BcZMGkTgxoA2BIOy
    • Locate the black tab that holds a wire in place that keeps the keyboard connected to the mother board.

    • Slowly unplug this wire that connects to the key board.

  6. LoQk5c4C6Y1RwvYI
    LoQk5c4C6Y1RwvYI
    PIs4u1eSiYNcOhiV
    • Use a Phillips #0 screwdriver to remove the 1.3 mm screw that holds the wireless card.

  7. yFBOL5AcGk1oy6DI
    yFBOL5AcGk1oy6DI
    l6EAwhmYqfWNsDMR
    • Remove the wireless card from the motherboard with your own hand.

  8. lhmTD4tSqxMbnk3W
    lhmTD4tSqxMbnk3W
    oukX1XyJCAlnJmUe
    • Find the wire that connects the screen to the motherboard.

    • Lift black tab that holds the wire in place.

    • Remove the wire.

  9. c3rRJSCPjrNGqjJf
    c3rRJSCPjrNGqjJf
    fyWMHXDL2ufJkutg
    • Find the display cable that connects the screen to the motherboard.

    • Lift black tab that holds the display cable in place.

    • Remove display cable.

  10. cgrZZ6lKQOl643ZK
    cgrZZ6lKQOl643ZK
    mMHVvEX2q1CoEVkV
    oXkZ2UOO4Dkn22ey
    • Use a Phillips #0 screwdriver to remove the four 1.3mm screws that hold the screen in place.

    • Two screws are on the left of the laptop and two are on the right of the laptop.

  11. 1cPhjMCPibeFiaJh
    1cPhjMCPibeFiaJh
    EisebX1USQ4JvGa2
    • Be careful when removing the screen so it doesn't get caught on any wires.

    • Remove the screen from the laptop.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Kyle DeMello

Member since: 20/10/17

542 Reputation

0 comments