Introduction

This guide describes how to replace a faulty motherboard in an HP Chromebook 14-x013dx. A malfunctioning motherboard could be due to overheating or other damage to the laptop. This replacement involves removing the laptop’s keyboard, and the total repair time should take about 25 minutes.

  1. 2MpsVZhHVFoFkqZ5
    2MpsVZhHVFoFkqZ5
    aLZHYvlpOJTPmDjm
    • Using the plastic spudger, gently lift the 5 rubber pads away from their seating.

  2. ylwGyDFtZYBNDmiT
    • Remove the five 6mm screws located under the removed pads using Phillips #00 screwdriver.

  3. dCeynpSZrYFxGfwW
    dCeynpSZrYFxGfwW
    5jmKE4BApFdVRsEL
    • With the Phillips #00 screwdriver, remove the remaining eight 6mm screws. You will now have thirteen 6mm screws removed from the case.

  4. QMZRx1BJV6igb6NH
    QMZRx1BJV6igb6NH
    xC5mKDMDYq6FMkOT
    • To continue removing the back cover, turn the laptop over as displayed.

    • Use the plastic spudger to gently pry around the base of the laptop from the back cover. Continue prying around the entire base of the laptop.

  5. LeqIb1ePZMUFxhyT
    LeqIb1ePZMUFxhyT
    4wQuchBXgn5GoYxT
    sqJmyfbfWKKN5r1E
    • Gently lift the silver base of the laptop from the bottom, but do not remove it.

    • To remove the ribbon cables, lift the latch holding the ribbon cables in place and then pull them free.

    • Remove the keyboard panel from the laptop.

  6. Cv1XHFbcvbhi1AYa
    Cv1XHFbcvbhi1AYa
    Ah3ikB1njKixUgh1
    • Remove the eight 4mm screws holding the battery in place using the Phillips #00 screwdriver.

  7. hVFFUNArqnNRwUnx
    hVFFUNArqnNRwUnx
    OHawTLdCoDKpGPus
    • Remove the ribbon cable that runs over the battery by lifting up the plastic latches and pulling the cable away.

  8. BOnEr2CqhojKK2Xm
    BOnEr2CqhojKK2Xm
    JvmMABVMRmsvrAmL
    • Unhook the battery's power connector from the motherboard.

  9. Itte6RSu4hWByVFR
    • Lift the battery out of the laptop case.

  10. ifFJAQcWxmPmT4qQ
    ifFJAQcWxmPmT4qQ
    hMJHoXONfGOEpvRP
    UegEH2ccOLZrS4MR
    • Carefully remove the 4 connections.

  11. eYvxfFNl6MciOjdM
    eYvxfFNl6MciOjdM
    um3NvqlxbXkpNojm
    o5lnjKReaVXMWckR
    • Using a Phillips #00 screwdriver, remove the seven 2mm screws holding the motherboard in place.

    • Gently lift the motherboard out of the laptop case.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Eile Woeltje

Member since: 06/11/19

304 Reputation

0 comments