Introduction

  1. FgsAW2N2AaDXGRCf
    FgsAW2N2AaDXGRCf
    gbYrYveJbaxQa5sW
    • Flip the device so that the back is facing up.

    • Peel the rubber stoppers off the top and bottom of the device.

  2. 4XZ6BjakMoAVZSmx
    4XZ6BjakMoAVZSmx
    qJD4qoGirK5OSWZA
    • Remove ten 3 mm screws from around the edge of the back panel using a T5 Torx screwdriver.

    The front 2 middle screws have a slightly thinner thread, so keep them to one side and put them back in the same holes.

    Mark Morgan -

  3. hHhbfWNRhSO6SGtX
    hHhbfWNRhSO6SGtX
    vxEUACJdsYpeheUn
    V36lYZ4G3pDEGpRL
    • Use an iFixit opening tool to pry up the back panel cover.

    • There is an orange ribbon cable that connects the cover to the base, so don't separate the two pieces completely.

    • Remove the single 2 mm screw using a Torx T3 screwdriver.

    • Disconnect the orange cable from the base of the device.

  4. mZdFPUjbCIEXpfYh
    • Insert wisdom here.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Kristen Gismondi

Member since: 12/11/14

81237 Reputation

0 comments