Garmin Drive 52 and Traffic Screen Replacement

Written By: Jason Wilson
  • Comments: 1
Garmin Drive 52 and Traffic Screen Replacement

Difficulty

Moderate

Steps

3

Time Required

15 - 30 minutes

Introduction

Welcome to this replacement guide for the screen of the Garmin Drive 52 and Traffic. The Garmin Drive 52 and Traffic is a GPS navigator that helps you find your way on the road. However, accidents happen and the screen of your device may get damaged or cracked. In such cases, replacing the screen can be a cost-effective solution to get your device back up and running. This guide will walk you through the steps required to replace the screen of your Garmin Drive 52 and Traffic. Please note that this procedure can be a bit tricky and requires some technical expertise.

Before beginning this repair turn off the device.

  1. ytdKXUCarFUYXH6o
    ytdKXUCarFUYXH6o
    qWS6Dk5jPg42mF6b
    NN1SHcjKSBcyMbqU

    • Pop the suction cup off of the device.

    • Unscrew the four T5 Torx screws on the back.

    • Carefully pry apart the front and back with a Jimmy.

  2. I6c26vi2r4tkfZSc
    I6c26vi2r4tkfZSc
    Ol6g2tYvugFWALCN
    OXIDtKOf6hgSwasZ

    • Pop the screen out of the front casing.

  3. dW3H435SEHZdxuOa
    dW3H435SEHZdxuOa
    amlenFfjjKrW3Cip

    • Flip up the ZIF connector's lock bar, remove the ribbon cable, and pull the screen out.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Jason Wilson

Member since: 26/10/22

388 Reputation

One comment

Is there some information about the pare part monitor? A possibility where to buy?

Sodob -