Fujifilm FinePix T500 Shutter and Power Button Circuit Board Replacement

Unscrew the six 3.5mm Philips head from the outer casing.

Open the battery chamber and remove the battery.

Pry the front half of the casing from the camera.

Be careful that the sensor cover—the small piece of translucent plastic—doesn't fall out of place. Return it to its original location if it does.

Pry the back half of the casing from the camera.

Lift the LCD screen out of the camera.

There is a tab that keeps in place the ribbon that attaches the screen and motherboard. Lift this up using the spudger and disconnect the screen from the motherboard.

Unscrew the 3.5 mm Phillips head screw from the corner of the camera.

Pry the center casing off the camera. This is best done by separating the top and side sections individually.

Unscrew the two 3.5 mm Phillips head screws in the metal plate.

Pry the metal plate out using the spudger.

Peel back the strip of black tape to reveal a red and black wire.

Detach the orange ribbon by gently pulling on it.

Detach the golden ribbon by gently lifting it with the spudger.

The lens should now be free to simply be pushed out of its socket.

The black and red wires that were exposed previously may be in the way of removing the lens and may break. If they do, you will need to solder these wires back into place upon reassembly.

Use tweezers to pull back the plastic covering the top of the camera.

Use tweezers to disconnect both the red and the black wires located next to the flash of the camera.

Pry off the top circuit board using the spudger.

Use tweezers to disconnect the blue and white wires on the underside of the camera.

Push the motherboard out of the camera body.

Detach the red, black, and white wires from the circuit board that you pried off earlier.