Framework Laptop 16" Touchpad Spacers Replacement

Written By: Alex Diaz-Kokaisl
  • Comments: 0
Framework Laptop 16" Touchpad Spacers Replacement

Difficulty

Very easy

Steps

4

Time Required

1 - 2 minutes

Introduction

Use this guide to replace one or both touchpad spacers in your Framework 16" laptop.

Note: the laptop used in this guide is a generic setup of one US keyboard, one numpad module, and two touchpad spacers. Your setup might vary, but the procedure should remain the same.

  1. FyZqYQXlGGSUVdfO
    FyZqYQXlGGSUVdfO
    ddbQkHnXk5QEvLfj

    • Unplug all cables and fully shut down your laptop.

    • If your repair requires a spudger, a T5 Torx, or a Phillips screwdriver, you can use the included Framework screwdriver. Whichever works best for you!

  2. Ij5tZGZrkdXZTD2w
    Ij5tZGZrkdXZTD2w
    LCNSyJH2IOKHeHb2
    4pRwkxTQGNlUhlIx

    • Use your fingernail to pull out the two Input Module latches and unlock them.

    • The latch will show red if it's unlocked.

  3. oRA2BGYySG6cv4UI
    oRA2BGYySG6cv4UI
    EjHQwVWhreadODGC
    Qd4HyChkTncRj6NB

    • Use your fingers to slide the touchpad spacer toward the bottom edge of the laptop and unclip it.

    • If you're having trouble, check if the corresponding Input Module latch is properly unlocked.

    • Lift the touchpad spacer off the laptop and remove it.

  4. PIQuXTPBOmiCmpTP

    • Repeat the same procedure for the other touchpad spacer.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Repair didn’t go as planned? Try some basic troubleshooting, or ask our Answers Community for help.

Author

Alex Diaz-Kokaisl

Member since: 16/01/22

117889 Reputation

0 comments