Eureka EasyClean 71C Bottom Cover Replacement

Written By: Tanner Durnil
  • Comments: 0
Eureka EasyClean 71C Bottom Cover Replacement

Difficulty

Moderate

Steps

4

Time Required

5 minutes

Introduction

This guide serves as a prerequisite only. The steps covered in this guide are used in all the replacement guides.

  1. ODTpitlvTRZOQTLw

    • Unscrew the two 18.1 mm PH2 Phillips head screws on the bottom of the vacuum.

  2. PmUaOAGXDMI5al6G

    • Pry off the Riser Visor using the plastic opening tool.

  3. 63npSLIoDVddugqk

    • Remove the screw cap using the metal spudger.

    • First-time removal of the screw cap can be difficult. The screw cap isn’t vital, so don’t worry about damaging the screw cap and just keep trying until it comes out.

  4. vphL3kAEymmRoNDu
    vphL3kAEymmRoNDu
    EuIGfiveFhVijYuO

    • Unscrew the 14mm PH2 Phillips head screw.

    • Pull the bottom cover off of the rest of the casing.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Tanner Durnil

Member since: 06/11/17

631 Reputation

0 comments