Eureka AirSpeed Bagless Zuum Vacuum Belt Replacement

Written By: Celina Burchett

Comments: 11

Eureka AirSpeed Bagless Zuum Vacuum Belt Replacement

Difficulty

Easy

Steps

Time Required

5 minutes

Introduction

If you determine that your vacuum is no longer picking up debris, is hard to push, or brush roll will not turn, this guide will help you to replace the belt.

Tools

Phillips #2 Screwdriver

Step 1

Step on the grey release button located between the two back wheels to lower the handle flat to the floor.
Insure the vacuum is unplugged before starting the process of removing the brush roll.

Step 2

Using a Phillips #2 screwdriver, remove the four screws from each corner of the brush roll cover.

Step 3

Remove the brush cover from the vacuum base, by pulling straight up.

Step 4

Firmly press upwards from below the brush roll on the side opposite the belt.

Step 5

After one end is displaced, remove the other side by pressing firmly upwards from below the the brush roll.

Step 6

Once the brush roll is displaced from the base, detach the belt from the brush roll in order to clean the brush roll.

Step 7

Remove the belt from around the motor.

the only thing I would suggest adding is a picture of the belt tensioner which also has to be removed to seat the belt properly.

bryanvd - 22/02/17

The Photos also look like 2 different vacuums as the Airspeed has yellow and a different panel. if it is the bagless 3000 series, its meant to engage the roller and easliy go from carpet to floor, which is the purpose of the big gray button. It is also a Type W belt.

bryanvd - 22/02/17

Under 'Tools' it says 'No tools required.'

Step 2. has you Using a Phillips #2 screwdriver. A screwdriver is a tool.

Tree Rey - 21/03/17