Introduction
If the motor is stuck this guide will help you to open the mixer and remove the motor.
Tools
-
-
This is what it looks like under the cover.
-
Slide out the two buttons and the small circuit board. The buttons are only snapped in.
-
-
-
The handle is fastened with a Torx T8 machine screw and a Torx T8 plastic screw. You will need a long screwdriver.
-
Remove two Torx T8 screws.
-
-
-
Unclip the handle from one side.
-
Unthread the cable, the buttons and the board.
-
The motor ist exposed. However, it is not yet completely accessible, since the lower plastic housing part cannot yet be slid over the bell. The bell must first be removed.
-
-
-
First try If the bell can be unscrewed. It is fastened with a left-hand thread, so turn it in the "wrong direction", clockwise, to loosen it.
-
Pull on the knife to remove it
-
If it does not come off easily, then slide the lower plastic part towards the bell and clamp the motor in a vice. Do not tighten the vice very much, the motor is sensitive.
-
Use a long screwdriver as a lever between the bell and the shaft. Then carefully unscrew the bell. Reminder: the wrong way round, i.e. clockwise.
-
Pay attention to the washer between the shaft and the bell, do not lose it.
-
-
-
Using a Torx T15 screwdriver unscrew the two screws securing the flange of the shaft to the motor.
-
Seperate the flange including the shaft from the motor.
-
-
-
Desolder the red and the white wire. These wires are thin and delicate, don't break them.
-
The motor remains.
-
To reassemble your device, follow these instructions in reverse order.