Introduction

  1. unnNZ5tXHmCgEBJI
    unnNZ5tXHmCgEBJI
    f5MfWPyBTRQH5sCE
    • Remove 4 Phillips head screws holding on the cover plate and gasket behind it.

  2. iFEIMp6Bp3jNfPcs
    iFEIMp6Bp3jNfPcs
    VWOyWceWTMb1UiIc
    KyUTWWt3GT3NZDBn
    • Remove bottom 9/16 nut that holds the pneumatic tube on the switch.

  3. srKF2qP3qCInAdfm
    srKF2qP3qCInAdfm
    dRwLIHRp3HjTvRbI
    • Thread the new switch into the pneumatic tube, careful threads are plastic.

    • Attach yellow wire to the top and the black wire to bottom of switch with disconnect.

    • Tighten 1/2 nut on the pneumatic tube until snug.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Trevor A

Member since: 16/09/21

1315 Reputation

0 comments