EDCO Floor Stripper TS8 .75L (2017) Blade Retainer Replacement

Written By: Robert Boyd
  • Comments: 0
EDCO Floor Stripper TS8 .75L (2017) Blade Retainer Replacement

Difficulty

Easy

Steps

5

Time Required

2 - 5 minutes

Introduction

This is a prerequisite-only guide! This guide is part of another procedure and is not meant to be used alone.

Follow this guide to remove and replace the blade retainer on an EDCO Floor Stripper TS8 .75L (2017).

The hood is removed in the photos, but the procedure is the same.

  1. DnshL2WqddCVCRL1

    • Before you begin, ensure the device is powered down and cool to the touch.

    • Ensure the machine is unplugged.

    • Turn the power switch counterclockwise into the OFF position.

  2. DEiALoepEXPqwPrb
    DEiALoepEXPqwPrb
    KsYwppvPLZYjfsUl
    OnwhFKKxBMiouTc6

    • Tilt the device back to rest on its handle.

    • Ensure that the four 9/16 inch motor mount bolts are tightened before tilting the device.

  3. JFUNfqYm1KYhvLDV

    • Insert wheel chocks behind the wheels to ensure the device does not move or fall during the repair."

  4. SZABbIl1dOUEDAVu

    • Use a 3/16 inch hex key to remove the three bolts securing the blade retainer.

  5. EQNwxxCtIE6klptp
    EQNwxxCtIE6klptp
    NBnX64DRudALx1g3

    • Remove the blade retainer.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Robert Boyd

Member since: 01/02/21

26261 Reputation

0 comments