Dyson Cinetic Big Ball Animal Upright Hose Replacement

Written By: Karla Sunjara
  • Comments: 3
Dyson Cinetic Big Ball Animal Upright Hose Replacement

Difficulty

Easy

Steps

4

Time Required

5 minutes

Introduction

The hose is located on the backside of the Dyson.

  1. wZVlkIfLgV3FsJrY
    wZVlkIfLgV3FsJrY
    hwtIfdAYPuWy4E22

    • Lift off the dust bin from the Dyson.

  2. cTVyDxoy1L3XFmHC

    • Locate the removable hose on the back of the Dyson.

    • Pull up on the hose in order to remove the top half of the hose.

  3. mvFhaSGuJHESlihL

    • Locate the red tab on the frontside of Dyson.

  4. VlQoRIldWQuANmJO
    VlQoRIldWQuANmJO
    ro6GVAuFTItLKDCD
    PlBxYhLJaKajcA5e

    • Lift up the red tab with the screwdriver while simultaneously pulling on the back hose.

    It’s the 6”-8*” hose beneath the long main hose I need to replace/reattach. Mine has disconnected from the end not in the picture (directly under the motor).

    Al Warren -

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Karla Sunjara

Member since: 25/01/17

822 Reputation

2 comments

Following step 4, I tried to “lift” the red tab with my screwdriver. It did not budge. After enlarging the photo, I saw that the tab can be seen from both sides. Therefore, I tried “pushing” the red tab instead of “lifting” it, and it popped right off. “Lifting” and “pushing” are different actions.

vlkea01 -

I've taken the small hose out (in the picture, it is in the center at the bottom of the balls) now I cannot get it back in - at one point I thought I had it snapped back in but it didn't stay - any ideas?

K BS -