Dyson Ball Animal Power Button Replacement

Written By: Hank Wai
  • Comments: 1
Dyson Ball Animal Power Button Replacement

Difficulty

Moderate

Steps

7

Time Required

10 minutes

Introduction

  1. OHAZQfoUQSvFXfXK
    OHAZQfoUQSvFXfXK
    2uWvhEOrojtNxrCu

    • Turn off and unplug the vacuum

  2. bcapQyaYLQcaDokC

    • Press the red release button and pull the canister up and away.

  3. mQoplNYgJbLKHWNu
    mQoplNYgJbLKHWNu
    yF2KGS5tWHdYaV3D

    • Locate the red dial at the back of the wand and turn counterclockwise to detach the wand.

  4. ov24V6mvXG2xFODj
    ov24V6mvXG2xFODj
    KQjjEdinoF6jJuWF

    • Remove the four 15mm screws behind the power button using a Torx T15 screwdriver.

  5. PWDcIxlXKBqDPBXS
    PWDcIxlXKBqDPBXS
    ib3ySESm4Tv12ndF
    HjPAWfWkoRGWtCJM

    • Use a spudger to push the two clamp tabs behind the power button towards the middle of the vacuum.

  6. h3WQ6ISevhJuXK2V
    h3WQ6ISevhJuXK2V
    VkR2KwGjCDOUZhsF

    • Detach the power box case from the body of the Dyson after both clamps have been pushed out.

    • Upon removal of this case, you will be able to see a red circular power button.

  7. 1egCFKXMyFRO4YZe
    1egCFKXMyFRO4YZe
    2XrHQPGb1ICMPcZd

    • Gently pull the power button out of its slot as shown.

    • Detach the power button box from the two wires connecting it, and replace the faulty power button box with a functional one. The power button is the first black one.

    So I got the housing off and the bare buttons work. A spring and a white plastic piece fell out. How do I put the spring, purple power cover, brush bar button cover and white piece all back on?

    Donna Robinson -

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Hank Wai

Member since: 08/05/17

166 Reputation

0 comments