Drill Master Heat Gun Fan Replacement

Written By: Mikayla Kim
  • Comments: 2
Drill Master Heat Gun Fan Replacement

Difficulty

Moderate

Steps

8

Time Required

15 - 30 minutes

Introduction

The internal fan keeps your machine from overheating. A faulty fan can also cause smoking. To remedy these problems, use this guide to replace your fan.

  1. EQOG1MHTmoxILqvY

    • Be sure the heat gun is unplugged before starting this process.

    • Remove the seven 14mm screws from the side of the drill using the PH#0 screwdriver.

    • You will need a screwdriver extension.

  2. P6pRM3Umrt1dup5T

    • Remove the 8mm screw from underside of barrel using the PH#0 screwdriver.

    • Don't try to open the casing just yet.

  3. pYDI1DqDnh6bKeBw
    pYDI1DqDnh6bKeBw
    rFJkhQF1LfWgRjAo
    nLYUEZmGeDQyQiRC

    • Remove the barrel casing on either end by twisting and pulling each side off.

  4. R1nm1JoNysRcIZ2A

    • Remove the top casing to reveal inside of drill. You might have to tug a little harder for this one.

  5. 1qVCRQVEEoiUBlyT

    • Remove the metal casing and fan cover from the fan unit.

  6. gpTRLVPJapnfZIeT

    • Bend the metal prongs backward that connect the fan motor to the plastic cap.

    • Bending the brackets too far back can cause the brackets to break.

  7. tl6cQkQldlbJZIaO

    • Remove the plastic cap from the motor,

    • This will allow you to work only with the motor and fan.

  8. 6dBEnMpukHIVIuHn

    • Remove the fan by pulling it from the motor rod and replace.

    Hi. Do you know where can i purchase a replacement fan for the motor? Mine has melted. Thanks!

    Randy Limson -

    Where can I buy the replacement fan?

    Fadi Dia -

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Mikayla Kim

Member since: 31/01/17

523 Reputation

0 comments