Dremel 8200 Disassembly

Written By: mitchellbarnhart
  • Comments: 2
Dremel 8200 Disassembly

Difficulty

Moderate

Steps

8

Time Required

15 - 20 minutes

Introduction

Disassembling your Dremel 8200.

  1. lALTOVtgQZL2CEnG
    lALTOVtgQZL2CEnG
    eiwtIZF5t54BBREX

    • Take off the screw cap at the top

  2. nYq1KvLDSVl3rMxK
    nYq1KvLDSVl3rMxK
    6l1PBcWR5wOpnLt1

    • Take out the battery

  3. Remove oblong belt clip

    • Remove oblong belt clip

  4. Hyx6FuqnVCYLrqQe

    • Unscrew screws

  5. Take back u clip out carefully

    • Take back u clip out carefully

    • Be very careful to not injure yourself

  6. EHsZOvEHbMrNxLKB
    EHsZOvEHbMrNxLKB
    Wx4xucYoSTGIfkXT

    • The casing should just open right up and be easily accessible

  7. EugA45UcMyv6E1nW

    • You can remove the buttons except for the sliding one that adjusts the speed

  8. 6RS4vPNfdDDYDR5x
    6RS4vPNfdDDYDR5x
    VsSPoSi5NYWDpYur

    • You can take the motor out first and it will be a little hard to do so

    • Work your way down and take out each successive circuit board

    • The last thing to be out should be the sliding speed adjustment and the button for that should fall right out

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

mitchellbarnhart

Member since: 19/02/15

86 Reputation

2 comments

It will be handy to have either a can of compressed air or an air directional nozzle on your compressor. Be careful of the circuits and small parts that can blow away. You'll be amazed how even with a maintenance schedule, how much dirt will be on the motor fins

m. D. w. -

How do you replace just the bearing in this assembly?

Andre Da Silva -