Dremel 7300 MiniMite Cordless Motor-Shaft Assembly Replacement

Written By: Michael Smith
  • Comments: 0
Dremel 7300 MiniMite Cordless Motor-Shaft Assembly Replacement

Difficulty

Easy

Steps

4

Time Required

5 minutes

Introduction

If the motor burns up or the power switch breaks, you are going to need a whole new motor and shaft for the device, as they come as one piece. This guide will show how to dissemble and remove the motor-shaft assembly.

  1. RV1Yn5ZQdpfFGGQm
    RV1Yn5ZQdpfFGGQm
    y3TOuFqbNOA1nooD
    GJlhNfZPiCUW24at

    • Pull back on the release tabs to disconnect the battery pack from the housing.

    • When installing a new battery, you may need to charge it before using it.

  2. fHo2UgETsWxsRZFf
    fHo2UgETsWxsRZFf
    lI5WE2yPXXHSN4pQ
    RpIYElJgfYfkSCfS

    • Remove the two screws from the back of the device with the TR10 Torx Security screwdriver.

    • Make sure you have removed the battery before proceeding as accidentally powering-on the device while disassembling is dangerous due to the high-speed components inside.

  3. rLE5PL1OoTKoxjTi
    rLE5PL1OoTKoxjTi
    wAnTPJDMFEokwqxv
    6KtGtiW6URxOZ4mI

    • Lift off the unscrewed plastic cover at an angle, away from the tip of the device.

    • Gently lift the cover. It won't take much force to remove it.

  4. gF3mRZYWebNsJuQ3
    gF3mRZYWebNsJuQ3
    YRkiTqpxVicmyRjt
    RJmSoJfbuL5DAbhD

    • Lift the tip of the motor-shaft assembly gently, then pull the assembly out.

    • The blue battery contact and the spring for the shaft lock button may pop out when you remove the motor-shaft assembly. Make sure to keep track of these pieces, as they are very small.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Michael Smith

Member since: 10/02/16

175 Reputation

0 comments