Introduction
Follow these instructions to learn how to remove the Olympus Stylus Tough-8010 camera's casing.
-
-
Remove the front three screws (3.2mm) using a type T-6 head screwdriver.
-
Take off smaller front cover.
-
Carefully remove larger front cover.
-
-
-
Remove two screws (4.1mm) on the top of the camera using a #000 Phillips head screwdriver.
-
Using a #000 Phillips head screwdriver remove two screws (7.9mm) near the control panel and set aside the metal connector.
-
-
-
Using a #000 Philips head screwdriver remove the two screws (4.1mm) on the right side of the camera.
-
Remove two screws (4.1mm) on the bottom of the camera using a #000 head Phillips screwdriver.
-
Remove the single screw (3.2mm) on the front of the camera using a #000 Phillips head.
-
-
-
Carefully remove the font panel piece from the rest of the camera.
-
Carefully remove the top/side plastic piece.
-
If you haven't already done so, remove the side casing as mentioned in Step 3. It is secured by a single screw near the bottom corner.
-
-
-
Remove four screws (9.4mm) on the front of the camera using a Phillips #000
-
Use the plastic opening tool to release the holding clip.
-
Using tweezers separate the plastic strips from their connectors located on the main circuit board by lifting the small, black flaps on the connectors and pulling on the ribbons.
-
To reassemble your device, follow these instructions in reverse order.
NOTE: you cannot remove the side piece until you complete steps 3 and 4 because there's a screw holding the corner of it which you can't see until you remove the front framework. You can just let the side piece hang there while you do that.
winntom -