Introduction

  1. il1iSt5ZhFYOnnYW
    • Turn off the camera.

    • Locate the power switch on the front of the camera below the camera lens.

    • Slide the switch to the off position.

  2. 6Kel5Oo5v2kbVm4G
    6Kel5Oo5v2kbVm4G
    cqKMHKqWcDJInr1M
    • Locate the 3 screws that hold the back cover to the camera.

    • One screw is located on the film opener side of the camera.

    • The other screws are located on the opposite side of the camera.

  3. WalkjXILJFEF3qyj
    WalkjXILJFEF3qyj
    3hdFrfyUx5vSFZNS
    M6NGCu1MSKSRjROI
    • Use the Phillips #00 Precision Screwdriver and remove the screws on the back cover.

  4. Lx3LhKBokqCa2r2H
    Lx3LhKBokqCa2r2H
    LYkjSAk5KTKQbWPT
    • Open the film door to remove the back cover.

    • Slide the film door lever to the left until the film door opens.

  5. vmMkSwWPOgSGOSI6
    vmMkSwWPOgSGOSI6
    PSPhWrFWQLNjM125
    • Use a plastic opening tool to pry the case open until a small gap is present.

    • Repeat this process at the top and bottom of the film door to loosen it.

  6. fVcckLOLTKCGeXSB
    fVcckLOLTKCGeXSB
    UmFMEAvuyVMDHKXr
    SI4icCvYAV41qei6
    • Grab the top and bottom of the case firmly as shown.

    • Gently remove the back of the camera case with a slight twisting motion.

Conclusion

To reassemble your device, follow these instructions in reverse order.

David Cottrell

Member since: 04/10/11

88 Reputation

0 comments