Dell Inspiron 15 N5040 Display Assembly Replacement

Written By: Terrence15
  • Comments: 2
Dell Inspiron 15 N5040 Display Assembly Replacement

Difficulty

Moderate

Steps

9

Time Required

5 - 10 minutes

Introduction

In this guide, we will be showing you how to remove and replace the Display Assembly.

  1. ALQuQhArGGpGHhBC

    • WARNING: Before working inside your computer, read the safety information that shipped with your computer. Follow the instructions in "Before You Begin".

    • CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as a connector on your computer).

    • Remove the two screws from the computer base.

    I have removed but not opening

    Rudranil Debnath -

    I have opened that screws but I can not open back panel

    Rudranil Debnath -

  2. RScUUJrXUrvDeVUP

    • Disconnect the display cable from the connector on the system board.

  3. N2rDWMS4ZbfKyDSx

    • Make a note of the display cable and Mini-Card antenna cables routing and remove the cables from the routing guides.

  4. nIIxgSLZFHykpJkg

    • Remove the four screws (two on each side) that secure the display assembly to the computer base.

  5. KspfBLvBWBQ4AZKj

    • Lift and remove the display assembly out of the computer base.

  6. 2wmwpNl2HgG6tOKb

    • Place the NEW display assembly in position and replace the four screws (two on each side) that secure the display assembly to the computer base.

  7. YYfROAdE1TYbpUeB

    • Route the display cable and Mini-Card antenna cables through the routing guides.

  8. eXtxmwiAga4dcNRh

    • Connect the display cable to the connector on the system board.

  9. tuxSmFGSXZhusimK

    • Replace the two screws to the computer base.

Author

Terrence15

Member since: 18/12/17

79034 Reputation

0 comments