Introduction

This guide will help you safely disassemble your unit and replace your existing damaged LCD. You will need a Phillips #000 screwdriver.

  1. 5KWTYRTEyrD4kN1k
    • Remove the battery and memory card from the device.

  2. UNfJGpsJlIgoo3yN
    UNfJGpsJlIgoo3yN
    SL3heHHYeZ4w2fAB
    • Remove 4 (2mm) screws from the bottom of the unit.

  3. UH4s6yJBSkncejEW
    UH4s6yJBSkncejEW
    2CjWGvkNURKvpgAV
    bK6piuOpm5MQW3Zd
    • Remove 4 (4mm) screws from the sides of the unit. You are removing screws from both the right and left sides of the unit (4 screws total)

  4. KwAEQDWh2J5WvoNW
    KwAEQDWh2J5WvoNW
    YFZeypLCZmdppnKh
    • Slightly lift up the left side of unit to remove the side panel. Do not remove the rear chassis. Just lift up enough to remove side panel.

    • Caution. The rear Chassis is attached to two ribbon panels so please do not remove the chassis in this step.

  5. pwHkUeRQmnSoKfWD
    • When opening the rear casing be careful not to pull on the flex cables. There are 2 flex cables on each side of the rear casing.

    • Slightly lift the rear casing. Do not completely remove it. Just lift just enough so the right flex clamp is visible. Keep in mind the left side of the rear casing is also attached to a flex clamp. Use a spudger or other method to release the cable. Do not remove the rear casing yet.

  6. nhffYV4yuJmsaMpY
    • Remove flex cable using a spudger or other method. Remove rear casing.

    • These plastic clamps are fragile and break easily. Use caution when releasing the cable. Use equal pressure throughout entire clamp or risk breaking the clamp.

  7. JFuXZKVQXPBEMKpG
    JFuXZKVQXPBEMKpG
    kyXnctON1Cgr2OGM
    • Insert wisdom here.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Sales Cameraparts4you

Member since: 01/07/16

3150 Reputation

0 comments