Corsair Dark Core RGB PRO SE Mouse Nano-Switches Replacement

Written By: Enzo Mello e Silva
  • Comments: 0
Corsair Dark Core RGB PRO SE Mouse Nano-Switches Replacement

Difficulty

Difficult

Steps

8

Time Required

1 - 2 hours

Introduction

If you have been using your Corsair Dark Core RGB Pro SE mouse for a while and noticed that it's becoming unresponsive or the clicks are not working properly, it could be due to worn-out mouse nano-switches. This guide will provide you with step-by-step instructions on how to replace the mouse nano-switches of your Corsair Dark Core RGB Pro SE.

  1. 1wAxRfMvO1d26Pri
    1wAxRfMvO1d26Pri
    EToAciBHuIT5E5O3

    • Cover the sensor on the bottom of the mouse with your thumb so it doesn't get damaged.

    • Use the heat gun on the bottom of the mouse to loosen the glue on the pads.

    • Repeat this step with the other glide pads.

  2. flgwoKK3XDpulJ1V

    • Remove the two screws from the bottom of the mouse using a T5 Torx screwdriver.

  3. PkxcP5RyQl66lfPe

    • Gently pry open the mouse shell using an iFixit opening tool.

    • Be careful not to force anything or use excessive force, as you may damage the components inside the mouse.

  4. wA3llGy1pgUBosOW

    • Use an iFixit opening tool to gently pry up the right and left click buttons on the top cover of the mouse until they pop out of place.

    • Be careful not to damage the wiring harnesses that connect the buttons to the PCB.

  5. BTIKyBrxyd6l1PKp

    • Use an iFixit opening tool to gently lift the top cover from the mouse body.

    • Be careful not to damage the wires connecting the cover to the mouse PCB.

  6. XwuWEnj2X2QV5lHc

    • Using a plastic opening tool, gently pry up the side button assemblies until they pop out of place.

    • Be careful not to damage the wiring harnesses that connect the buttons to the PCB.

  7. 3WsXKaHXWRTTGBwX

    • Remove the screws that hold the circuit board in place using a Phillips #0 screwdriver.

    • Gently lift the PCB and set it aside.

  8. KtYTwqUALGZZZVWE

    • With the nano-switches now exposed, use a soldering iron to melt the solder holding the old switches in place.

    • Use tweezers to carefully remove the old switches and desolder any remaining solder.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Enzo Mello e Silva

Member since: 09/02/23

145 Reputation

0 comments