Introduction

This guide will walk users through replacing the cooling fan of the Chromebook x360 14-da0011dx. Fans accumulate debris and dust over time, causing malfunction or reduced function. If possible, clean fan debris and retry connection before replacing the fan altogether.

  1. xgaiSYuyOGuhDvgG
    • Flip the device over with the hinge facing away from you.

    • On the back of the device, remove the two rubber strips on the top and the bottom of the device using a spudger.

  2. WKlCqBMAIRWm6VY5
    WKlCqBMAIRWm6VY5
    kTQpM2fTLC6leu5W
    • Remove the seven 8.0 mm screws located under the two rubber pads and the screws along the back of the device using a Phillips #1 screwdriver.

  3. oOUhJS4EKqd3QJef
    oOUhJS4EKqd3QJef
    1MLaVKi1RgDksfrM
    fUpMSpMmaEpYapAS
    • Use a spudger to gently pry the edges of the back cover off the device. Slowly work all the way around the device until the panel comes loose.

  4. WKVA2eyirIubapUU
    WKVA2eyirIubapUU
    cYU4NdnZsiPHKuTF
    • Remove the cable attached to the battery.

  5. Ss1oQcyXgUjRLNsQ
    Ss1oQcyXgUjRLNsQ
    nJAmRoQnQBmHTnXP
    • Remove the five 3.0 mm screws holding the battery in place using the Phillips #1 screwdriver.

  6. hIgx5dPja22VHKtZ
    • Lift the battery out of the chassis.

  7. 3yAeVsEfcgBhaXat
    • Remove the two 3.0 mm Phillips #1 screws holding the fan in place.

  8. PnBZ6jcORD14tZSh
    PnBZ6jcORD14tZSh
    AUGsA2JYgmeXLLrr
    • Disconnect the fan cable from the motherboard.

    • Carefully remove the fan from the computer.

    • Be careful when removing the fan, as it sits under one of the CPU heat pipes and tucks under the ribbon cable that runs to the I/O board.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Jake Williamson

Member since: 14/02/23

559 Reputation

0 comments