Canon EOS Rebel G Grip Replacement

Written By: Kyle Reis
  • Comments: 0
Canon EOS Rebel G Grip Replacement

Difficulty

Moderate

Steps

6

Time Required

10 - 15 minutes

Introduction

This guide shows you how to install the grip on your camera.

  1. NEVGWMkZBAxyLAXV

    • Using a #00 Phillips screw driver, remove three 4.4 mm Phillips screws as indicated by the red circles.

  2. TgWY24VK461rRb2P
    TgWY24VK461rRb2P
    YsYNhMPUVt1pAeVx

    • Using your finger, peel back the textured grip so the components are separated.

  3. WUtpnyKjcAyBnPcp
    WUtpnyKjcAyBnPcp
    CnPNxUvtCpknxsRA
    bDCxHGA3UTIArKuB

    • Using the flat end of a spudger, loosen the connection between the front panel and the device.

    • Remove the front panel using your hands.

  4. gKUspv6x1AXZcoTo

    • Using a 00 Phillips screw driver, unscrew the two 4.9 mm Phillips screws. on the inside of the camera.

  5. dZG5AjonalsoM26P

    • Using a 00 Phillips screw driver, unscrew the two 4.3 mm Phillips screws on the side of the camera.

    • Use your fingers to pull out the plug that is located between the screw holes.

  6. iOkajBbXLdnKFFad
    iOkajBbXLdnKFFad
    jZlcVMvhYdSBSVKa

    • Use the flat end of a spudger to pop the grip off and remove grip.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Kyle Reis

Member since: 02/04/12

52 Reputation

0 comments